Diesel Engine Fire Pump 1
| Inspection, Testing & Maintenance Diesel Engine Fire Pump | Scope |
| Tank level | Visual Inspection Checking |
| Tank float switch | Visual Inspection Testing |
| Solenoid valve operation | Visual Inspection Testing |
| Water in system | Checking Cleaning |
| Flexible hoses and connectors | Visual Inspection |
| Oil level | Visual Inspection Checking |
| Lube oil heater | Checking |
| Level (Cooling system) | Visual Inspection Checking |
| Adequate cooling water to heat exchanger | Checking |
| Water pump(s) | Visual Inspection |
| Condition of flexible hoses and connections | Visual Inspection Checking |
| Jacket water heater | Checking |
| Leakage (Exhaust system) | Visual Inspection Checking |
| Drain condensate trap | Checking |
| Electrolyte level (Battery system) | Checking |
| General inspection | Visual Inspection Cleaning |
| Pump house, heating ventilating louvers | Visual Inspection Checking |
| Drive Belts/Hose | Visual Inspection Checking |
| Case exterior clean and dry (Battery system) | Testing |
| Specific gravity or state of charge (Battery System) | Visual Inspection |
| Charger and charge rate (Battery system) | Checking |
| Equalize charge (Battery system) | Checking Fire Alarm |
| Circuit breakers or fuses (Electrical system) | Visual Inspection |
| Air/Suction Filter | Visual Inspection Checking Cleaning |
Fire Pump System Checklist 2
| Inspection, Testing & Maintenance | Scope |
| Strainer, filter or dirt leg or
combination of thereof | Cleaning |
| Crankcase breather (Lubrication
system) | Visual Inspection
Changing Cleaning |
| Water strainer (Cooling system) | Cleaning |
| Insulation & fire hazards (Exhaust system) | Visual Inspection |
| Terminals clean and tight (Battery
system) | Visual Inspection
Checking |
| Wire chafing where subjected to movement (Electrical system) | Visual Inspection
Checking |
Fire Pump System Checklist 3
| Inspection, Testing &
Maintenance | Scope |
| Lubricate pump bearings | Changing |
| Check pump shaft end play | Checking |
| Check accuracy of pressure
gauges and sensors | Checking
Changing |
| Check pump coupling alignment | Checking |
| Lubricate coupling | Changing |
| Lubricate right-angle gear drive | Changing |
| Trip circuit breaker (if mechanism provided) | Testing |
| Inspect and operate emergency manual starting means (without power) | Visual Inspection Testing |
| Tighten electrical connections as necessary | Checking |
| Lubricate mechanical moving parts (excluding starters and relays) | Checking |
| Calibrate pressure switch settings | Checking |
| Grease motor bearings | Changing |
| Water and foreign material in tank | Cleaning |
| Tank vents and over flow piping unobstructed | Checking
Testing |
| Piping | Visual Inspection |
| Rod out heat exchanger | Cleaning |
| Inspect duct work, clean louvers (combustion air) (Cooling system) | Visual Inspection
Checking Changing |
| Excessive back pressure (Exhaust system) | Testing |
| Exhaust system hangers and
supports (Exhaust system) Diesel Engine Fire Pump | Visual Inspection |
| Clean terminals (Battery system) | Cleaning |
| Tighten control and power wiring connections (Battery system) | Checking |
Trackbacks/Pingbacks